EVO Rear Axle Swap Bracket Kit – 2020–2026 Jeep Gladiator JT

A weld-on rear-axle conversion bracket set for a properly engineered Gladiator JT axle swap. This is NOT a complete axle, bolt-in lift kit or universal axle-fitment guarantee.

Fitment and included parts

• Intended for 2020–2026 Jeep Gladiator JT rear-axle swap fabrication. The installer must establish axle width, tube size, bracket locations, pinion angle and complete suspension/brake compatibility for the actual donor axle.
• Raises the axle mounting locations approximately 2 inches for ground clearance and suspension geometry. This does not establish a 2-inch vehicle lift height.
• The manufacturer BOM lists 21 fabricated pieces across 13 part-number lines: forward/rearward track-bar brackets and track-bar gusset; driver/passenger lower-control-arm and sway-bar mounts; two inner and two outer upper mounts with two gussets; four shock tabs and two shock-mount plates; driver/passenger spring/bump-stop mounts and two spring tubes.
• Measure the actual axle-tube profile and bracket openings before fabrication. A radiused opening is not a universal axle-tube fitment declaration.

Required supporting parts and installation

• Professional fabrication is required, including cutting, grinding, positioning and welding. Measure and tack-fit the complete suspension before final welding, then verify full bump/droop articulation and all clearances.
• Brake and parking-brake attachment provisions are NOT included. The installer must provide a suitable solution and verify brake-line routing, retention and operation.
• An axle assembly, differential, shafts, brakes and other complete-axle hardware are not supplied. Do not buy this bracket set expecting a ready-to-install axle.

Manufacturer installation instructions

Confirm the exact part number and your build requirements before ordering.